SAW Metallization Study

Follow

Overview

SAW metallization presents the designer with a great deal of variables. OnScale can be used to clearly present the design trade offs which exist, allowing the optimum design to be reached quickly.

In this example we vary both the aspect ratio of the SAW electrode fingers and the thickness of the electrode layer itself.

Model Setup

A schematic of the model and the two input variables can be seen below:

The key model parameters were as follows. Electrode thickness and electrode aspect ratio are set as design variables to be swept (indicated by *)

Design Variable Description Default Value
elec_thk * Thickness of electrode  200 nm
subs_thk Thickness of substrate  7.5 um
fin_pitch Finger pitch  1.3 um
aratio * Metalization aspect ratio  0.5
nfing Number of pairs of fingers in full device  100
fin_len Length of fingers  50 um
piezo_mat Piezoelectric material  lt (LiTaO3)
cut_ang  Rotated y-cut angle  0.5

 

Input variables were swept as follows:

  • Aspect ratio:   0.4 – 0.6 (10 steps)
  • Electrode thk: 180 – 220 nm (10 steps)
 

Simulation Sweep Results

The full simulation sweep was completed in 3 minutes when using 8 cores per simulation and had a total cost of 40 core hours.

Using the outputs from the simulations, it is possible to calculate the device impedance, Q factor and resonant frequencies. These outputs can all be plotted against the input variables to provide an insight into the device performance. Results are plotted below.

0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.