Help with Model Dimensions Answered

Avatar
David Harra

I am needing help to obtain specific material dimensions for a titanium homogeneous model with an array configuration.

Normally I use a table file which reads in my grain data to plot the material.  I have tried to do this with a homogeneous material but I don't believe I am getting the same size as the grain model. 

Other parts of my model I am not comfortable with is the way I have my array set up. Line 43 may cause issues when setting up my geometry which affects my keypoints.

I would need help with Lines 43 to 76 Just to make sure my geometry and key points are doing as intended. Line 50 doesn't seem to be getting used although I thought the formula here was important for the array? Then Line 172 where I site my material with the array to get the desired output.

I have commented out all the lines that are relevant to the grain model. 

Any help would be appreciated.

Thanks
Dave :) 

3 comments

  • Avatar
    Tapiwa Mutasa

    Is your post missing a file? 

    Comment actions Permalink
  • Avatar
    David Harra

    Hi Tapiwa. 

    For some reason, anytime I share my strathclyde one drive OnScale can't access it. I could easily email it over to you if that is Ok?

    Thanks

    Dave :)

    Comment actions Permalink
  • Avatar
    Tapiwa Mutasa

    That's fine. Please send it to our support email along with your question.

    Thanks,

    Comment actions Permalink

Please sign in to leave a comment.

Didn't find what you were looking for?

New post