Plotting Impedance in Water Answered

Hi there,

I am trying to get the impedance plot of a transducer in water but the output I get is very noisy as shown below. I have a long simulation run time of 0.8 seconds but even with this, the charge does not completely fall to zero which I think might be causing the problem. I have added a damping resistor of 700 Ohms. Is there anything else I can do to make the impedance plot clearer? 

1 comment

  • Hi Laura,

    Are you able to share your model with us via your preferred cloud sharing service? 0.8 seconds is a long time. What is your frequency of interest? Is it a very low frequency transducer? If it is, there are a few things that can be done to help this like zoning

     

    Best Regards,

    Chloe

    Comment actions Permalink

Please sign in to leave a comment.

Didn't find what you were looking for?

New post