Tiffany

1. Community
2. OnScale Lab (Desktop Application)
3. OnScale Cloud Failures

I will read the article you sent. However, I switched the starting value and I still get crashing. Additionally, it crashes sometimes when I run one at a time. 

• View comment
• Created September 01, 2020 10:41
• 0 votes

1. Community
2. OnScale Lab (Desktop Application)
3. OnScale Cloud Failures

Hello Chloe, I tried lowering the stability factor, increasing my meshing, and replacing the absr to impd. But it still fails especially at higher frequencies. The error report is saying there is a...

• View comment
• Created August 31, 2020 07:04
• 0 votes

1. Community
2. OnScale Lab (Desktop Application)
3. Applying a pressure load

Hello Chloe, Thank you for the reply. I updated the site block as you suggested but it still does not run. Should I also be using the same syntax for defining the pressure region for the plod comma...

• View comment
• Created August 17, 2020 18:00
• 0 votes

1. Community
2. OnScale Lab (Desktop Application)
3. Spline tool not working

Thank you. What do i, J, and K stand for? Also, what does 50 mean?

• View comment
• Created July 19, 2020 07:03
• 0 votes