4件のコメント

  • 正式なコメント

    Hi,

     

    You can change the data range of the plot using the User defined data range:

    Designer cannot output pres, this has to be done in Analyst by adding out pres to the data command. Prmx is the same as apmx just with a different name. You can change the names of the data arrays by copying them into a new array using data copy in Analyst.

    コメントアクション Permalink
  • Thank you. I also want to ask when I simulate my model, then observe the result like "apmx", the highest pressure always occur inside the transducer, but the example graph I mentioned above didn't, how to filter out the pressure of the transducer (the piezoelectric crystal)?

    コメントアクション Permalink
  • You can copy the maximum pressure in the water alone into a new data array using data cpyg (see command reference) and specifying the nodal indices of the water area.

    Best Regards,

    Chloe

     

    コメントアクション Permalink
  • But how to create a new data array? That is I don't know how to type the "datanameto" parameter.

    コメントアクション Permalink

サインインしてコメントを残してください。

お探しのものを見つけられませんでしたか?

新規投稿