Chloe Allison

正式なコメント

1. コミュニティ
2. OnScale Lab (Desktop Application)
3. "Surface is not within uniform material" - Pulse Echo Simulation

Hi Eamon,  Thank you for reposting on our forum. Your extrapolation boundary was set to be at $j2+5 which is at node 10 which is in the piezo material. This not allowed by the solver as this is a n...

• コメントを表示
• 0 件の投票

正式なコメント

1. コミュニティ
2. OnScale Lab (Desktop Application)
3. Running a long simulation, checked back hours later and it had paused?

Hi Laura, The simulation should keep running as long as you computer is not asleep. It sounds like you may have had a term command in the code which pauses the code execution. If you wish to run th...

• コメントを表示
• 0 件の投票

正式なコメント

1. コミュニティ
2. OnScale Lab (Desktop Application)
3. Getting the axial pressure

Hi Laura, For what you are describing you should use extrapolation (option 2) to get the pressure at an axial distance from the hyrdophone. This will give you a pressure time signal at that node. Y...

• コメントを表示
• 0 件の投票

正式なコメント

1. コミュニティ
2. OnScale Lab (Desktop Application)
3. Impedance Magnitude Difference

Hi Laura,   The amplitude difference is likely due to incorrect material properties. Since it is an amplitude difference it is likely that dielectric properties for the piezo in the simulation does...

• コメントを表示
• 0 件の投票

1. コミュニティ
2. OnScale Lab (Desktop Application)
3. OnScale to matlab

Hi Dave, We got your files through, we will look into this and get back to you as soon as we can. Best Regards, Chloe

• コメントを表示
• 0 件の投票

正式なコメント

1. コミュニティ
2. OnScale Lab (Desktop Application)
3. Is it possible to create a crack with some angle?

Hi Parks, It isn't possible to create a crack at an angle using debond unfortunately.   Best Regards, Chloe

• コメントを表示
• 0 件の投票

1. コミュニティ
2. OnScale Lab (Desktop Application)
3. Area pressure in 3D simulation

Hi Parks,   If you open the command reference available in the Help Tab and search for site cyln this is the command you need to use to create a cylinder in Analyst.   Best Regards, Chloe

• コメントを表示
• 0 件の投票

正式なコメント

1. コミュニティ
2. OnScale Lab (Desktop Application)
3. Guided wave simulation

Hi Parks,   Yes this is possible. Here is a written example.   Best Regards, Chloe

• コメントを表示
• 0 件の投票

正式なコメント

1. コミュニティ
2. OnScale Lab (Desktop Application)
3. How can I create point source at onscale?

Hi Hyunjae Song, You can create a sphere or circle using primitive shapes and load the surface of that using Geometry Interface. Best Regards, Chloe    

• コメントを表示
• 0 件の投票

1. コミュニティ
2. OnScale Lab (Desktop Application)
3. what is the meaning of bad value

Hi there, Yes, here is an article explaining this. Best Regards, Chloe

• コメントを表示
• 編集済み 2021年04月13日 10:07
• 0 件の投票