Chloe Allison
コメント
-
Hi SD, Have a look at this article that covers this error - https://support.onscale.com/hc/en-us/articles/360007264097-Troubleshooting-errors Best Regards, Chloe
-
正式なコメント
Hi Sarah, Unfortunately we do not currently have this functionality in OnScale. However, we are in the process of developing a Matlab Toolbox which allows you to control job submission and post-p...
-
Hi, So I had a look at your model. Everything looks set up correctly. The acoustic pressure output is less energy because the wave loses energy as it propagates. This amount will change depending...
-
Hi Ushna, I cannot access your file. Best Regards, Chloe
-
Hi, I will also need the code for matr.prjmat. Thanks, Chloe
-
正式なコメント
Hi Ennasar, We have changed the functionality, you can use polyhedron and change the number of points to make a hexahedron or tetrahedron. Best Regards, Chloe
-
正式なコメント
Hi Ennasar, Please share your .*flxprt file and we will help you understand the problem. Best Regards, Chloe
-
I just wanted toyour pre check to make sure your code was correct. So the output signal is not 1 MPa? Could you share your files via your preferred file sharing service and I can take a look for yo...
-
正式なコメント
Hi there, The output signal will depend on the drive function you are using. What code are you using in func command? If you want to load the interface between waternl and waternl_1 then the code...
-
Hi there, The system has reached a steady state when the charge has rung down enough that the amplitude is almost zero. You can see that in your model the charge rings down and then starts ringing ...