Chloe Allison
コメント
-
正式なコメント
Hi Olubunmi, Welcome to the forum. Here are a few resources I recommend for beginners: Introduction to OnScale Introduction to Designer Intorduction to Analyst We have two methods in which y...
-
正式なコメント
Hi, Please tell us your current email linked to your account and what email you would like this to be changed to. Best Regards, Chloe
-
正式なコメント
Hi Eamon, Thank you for reposting on our forum. Your extrapolation boundary was set to be at $j2+5 which is at node 10 which is in the piezo material. This not allowed by the solver as this is a n...
-
正式なコメント
Hi Laura, The simulation should keep running as long as you computer is not asleep. It sounds like you may have had a term command in the code which pauses the code execution. If you wish to run th...
-
正式なコメント
Hi Laura, For what you are describing you should use extrapolation (option 2) to get the pressure at an axial distance from the hyrdophone. This will give you a pressure time signal at that node. Y...
-
正式なコメント
Hi Laura, The amplitude difference is likely due to incorrect material properties. Since it is an amplitude difference it is likely that dielectric properties for the piezo in the simulation does...
-
Hi Dave, We got your files through, we will look into this and get back to you as soon as we can. Best Regards, Chloe
-
正式なコメント
Hi Parks, It isn't possible to create a crack at an angle using debond unfortunately. Best Regards, Chloe
-
Hi Parks, If you open the command reference available in the Help Tab and search for site cyln this is the command you need to use to create a cylinder in Analyst. Best Regards, Chloe
-
正式なコメント
Hi Parks, Yes this is possible. Here is a written example. Best Regards, Chloe