SD
投稿
-
thermal simulation
Dear, I am trying to extract thermal result of a model. I build the simulation based on the unit cell onscale example. the model I am running has a SAT file input and a user file driving function....
-
回答済み
Define Input Drive Function
Dear, I am trying to input pulsed signal however I get the first pulse only when I use User Defined option. The file is in .dat format. Saved the file as txt format and the following are the first ...
-
回答済み
thermal model
Dear, Hope you are doing well. Is it possible to get the result of the thermal response after running pressure simulation for the entire model? For example like apmx or pmax as an output. model...
-
no-error
Dear, Hope you are doing well There are no errors however, it doesnt estimate on Run on cloud neither it gives an error. Also, the run option is greyed. There was an error that z is not posit...
-
回答済み
Thermal analysis of soft tissue
Dear, Does Onscale simulate the thermal difference specifically on soft tissue before and after exposure to ultrasound, or just thermal difference on the entire model itself? If it does simulate ...
-
回答済み
Transformer result
Dear, The impedance result that I get is for the transducer piezoelectric in designer mode, not the model. Added a transformer to match the outlet impedance but the result does not change. Went thr...
-
回答済み
Transformer
Dear, I'm trying to add a transformer to the transducer model to match the impedance, transducer impedance is 284. Went to add a circuit>> transformer>> 0.177 as a turn ratio. The output remained...
-
回答済み
Model won't run when changing mesh size
Dear, Built a transducer model, but it won't run on any mesh size above 5 elements per wavelength. I tried by removing the loads after changing mesh size and re-added them after, but the problem ...
-
回答済み
Load error
Dear, When applying the force function to a load, the simulation would not run with this message, (0 nodes have been added to electrode load_3), although applied the forcing function to the load....
-
回答済み
Model Syntax Error
Hello, I'm trying to run the transducer on a cloud but it keeps giving this following error message "Your model failed to estimate due to a syntax error in the input deck. Please check your working...