Chloe Allison
コメント
-
Hi there, I am unsure what you mean by settling commands? Do you want create a loop through the points? Best Regards, Chloe
-
Hi there, This error means there is something wrong with your setup. You can find the source of the error in the file generated ending in -estimate.flxprt. Best Regards, Chloe
-
Hi Ali, Check out this video for extracting impedance. From the impedance, you can extract the resonance/anti-resonance frequencies. Best Regards, Chloe
-
If your model is failing the estimate, a flxprt file will be generated in the same directory of the file you are estimating. Best Regards, Chloe
-
Hi Abdul, What do you mean by you cannot open the flxprt file? Have you downloaded it from the cloud? 1000 elements per wavelength will be an extremely large model. We recommend using 15 elements...
-
Hi Abdul, You can check the generated 'filename-estimate.flxprt' file for the error message. My guess is that you haven't increased the mesh for the lower frequency so the mesh is likely too coarse...
-
Hi Dave, The batch controller doesn't allow this unfortunately. You would have to create a control file yourself to do this. The code would look something like this: c Inputssymb var1beg = 1e-3sym...
-
正式なコメント
Hi there, See this article for how to run parametric sweeps. Best Regards, Chloe
-
Hi Sara, It looks like you are applying an absorbing boundary condition on a piezoelectric material (pmt3). This is not allowed. Which tutorial are you following, could you provide me the link plea...
-
Hi Akarsha, Yes for that example it should be set to axisymmertric, however it does not look like you have followed the steps after that to create the correct model. It should look like this: Best...