박기융
投稿
-
回答済み
2d model / 3d model difference
I made a simple pzt disc with 2D designer and 3D designer. I set all of the variable same, but there is little differences.Below is the result of Piezo top displacement in 2D(Black) and 3D(Blue). I...
-
回答済み
simtime in analyst mode
Hi I have questions about simtime in analyst mode c Runtime calculationssymb #get { step } timestep /* Extract calculated timestep from PRCS commandsymb simtime = 20 / $freqint /* Simulat...
-
回答済み
simulation run time
Hi these days i am studying about analyst mode and i have a questions. I understand "simtime" in analyst mode is same as a "simulation run time(s)" in designer mode. But if i change the input frequ...
-
回答済み
watr -> air
Hii want to see the acoustic pressure movement for simple PZT 2D DISC (tx/rx) like this example (https://support.onscale.com/hc/en-us/articles/360019958231-PZT-Disc-2D-TxRx-) but if i change water ...
-
回答済み
analyst mode to designer mode
HiI want to get same output from this examples in onscale website(PZT disc 2D (Tx/Rx)https://support.onscale.com/hc/en-us/articles/360019958231-PZT-Disc-2D-TxRx- This example is made from analyst ...
-
回答済み
3D Symmetric
Hi i want to see the cross section view of 3d PMUT, so i made half of it and use symmetric to see the cross section.Actually, i did get a cross section view, but now i want to see the whole PMUT, i...
-
回答済み
2D symmetric(Y axis) / area scaling
Hi i have some questions about shape of model of 2D y-axis symmetric mode.I always get an result of 2d y-axis symmetric as half cylinder,but if i want to get model as cylinder, is there any way i c...