Chloe Allison

Official comment

1. Community
2. OnScale Lab (Desktop Application)
3. Damping in Material Property

Hi there,   To answer your questions:   1.The units are decibels per centimetre at damping frequencies in MHz, the MHz is just letting the user know that the damping frequencies must be specified i...

• View comment
• Created January 05, 2021 11:15
• 0 votes

Official comment

1. Community
2. OnScale Lab (Desktop Application)
3. excite pure shear wave

Hi there,   You can set the vector to be parallel to the plane surface in the vctr command. However, the wave will not be perfect because it is on a stair stepped surface. You can increase the mesh...

• View comment
• Created December 22, 2020 10:49
• 0 votes

Official comment

1. Community
2. OnScale Lab (Desktop Application)
3. Problem of wave propagation direction

Hi there, You can set the propagation direction of the wave using plod vctr. In this case it would be plod vctr 1 0 0. Because you are loading between two water materials some of the wave will prop...

• View comment
• Created December 22, 2020 10:26
• 0 votes

Official comment

1. Community
2. OnScale Lab (Desktop Application)
3. Area Scaling for 2D Axi-symmetric Model

Hi Nicolas, The information in 'How to apply symmetry' may be slightly misleading, none required really means this is calculated by default. Axisymmetry calculates 1 radian sector of the model so t...

• View comment
• Edited December 10, 2020 11:40
• 0 votes

Official comment

1. Community
2. OnScale Lab (Desktop Application)
3. Error Submitting Job

Hi Vigneshwar,   Please refer to this article.   Best Regards, Chloe

• View comment
• Created December 07, 2020 10:20
• 0 votes

Official comment

1. Community
2. OnScale Lab (Desktop Application)
3. Is is possible to simulate breathing crack?

Hi there,   Yes that is possible using our debond (modl dbnd) command (see Command Reference for more details). Here is a very simple example of how to set this up. I hope this helps.   Best Regard...

• View comment
• Created December 04, 2020 14:52
• 0 votes

1. Community
2. OnScale Lab (Desktop Application)
3. "your account ... may not use onscalelab !job.not.allow.onscalelab!"

Hi Jinny,   Unfortunately this is happening to some older users also. If you email sales@onscale.com they will get this sorted for you asap.   Best Regards, Chloe

• View comment
• Edited December 01, 2020 14:11
• 0 votes

1. Community
2. OnScale Lab (Desktop Application)
3. Omission of key primitive element in my model

Hi Lukman, It is hard to comment without being able to see the model but a couple of things to try: Use free boundaries instead of absorbing Place a time history within the tube material and see i...

• View comment
• Created November 17, 2020 13:53
• 0 votes

Official comment

1. Community
2. OnScale Lab (Desktop Application)
3. Omission of key primitive element in my model

Hi Lukman,  There are a couple of reasons why the tube might not be showing up in the model. Here are some tips to try: Co-ordinate definition is in the wrong order – Primitives are defined using b...

• View comment
• Created November 11, 2020 11:15
• 0 votes

Official comment

1. Community
2. OnScale Lab (Desktop Application)
3. permittivity at constant strain

Hi Mohamamd,   Have a look at this article.   Best Regards, Chloe

• View comment
• Created November 10, 2020 10:19
• 0 votes