Chloe Allison
Comments
-
Official comment
Hi Alex, You need to use the root option in piez nod2 when you want to load lots of materials that start with the same word. Best Regards, Chloe
-
Hi Alex, Can you share your file via your preferred cloud file sharing service and I will take a look for you. Best Regards, Chloe
-
Hi Yang Song, Your block is only being pushed upwards in the left bottom corner, is this correct? Also, how did you get the data for figure 1? What are the x and y axes on figure 1? You may want ...
-
Hi there, Can you please share your 'time_force.dat' file via your preferred file sharing service and I will take a look for you. Best Regards, Chloe
-
Hi Maju, I think the absorbing boundaries may be introducing artefacts at the corners. To combat this you can bend your model into a circle so the absorbing boundary is a smooth surface. This will ...
-
Hi Maju, We typically suggest creating point sources by adding a circular primitive with a dummy material and loading the outside surface of that primitive using the material interface. So, for you...
-
Hi Maju, When you say the more resolved simulations are so slow, how slow do you mean? There are a few ways models can be sped up but I would need to take a look at the full code to make suggestion...
-
Hi, Our apologies - PZFlex is no longer maintained or supported by OnScale. If you like, we can arrange a demo of the new capabilities of OnScale, which extends the core PZFlex capabilities with ne...
-
Hi there, The maximum amount of core hours available for a single job is set to 150 CHs by default. You can increase this by going to the portal > Accounts then click on your email address and edit...
-
Hi Megan, Can you please tell me the email linked to your account and I can look into this for you. Best Regards, Chloe