Avatar

Oliver Mashari

  • Total activity 143
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 1 user
  • Votes 5
  • Subscriptions 85

Activity overview

Latest activity by Oliver Mashari
  • Oliver Mashari created an article,

    Flow 3D

      Model Description A 3D model of a pipe with a parabolic flow profile in Y direction across the radius of the pipe. With the flow velocity set in positive X direction, the model can be used to ev...

    • Edited
    • 1 follower
    • 0 comments
    • 0 votes
  • Oliver Mashari created an article,

    Flow 2D Parametric Sweep

    In this example we will demonstrate how to set up a parametric sweep, we simulate a 2D flowmeter example with different flow velocities to see how this changes the signal recorded at the receiver....

    • Edited
    • 1 follower
    • 0 comments
    • 0 votes
  • Oliver Mashari created an article,

    Flow 2D

    This is a modelling guide to help you get started simulating the effects a flow field and its influence on the propagation of an acoustic wave. This example will show you how to set up a 2D model o...

    • Edited
    • 1 follower
    • 0 comments
    • 0 votes
  • Oliver Mashari commented,

    Hi Kaleeswaran, Potentially stupid question: have you downloaded the results after the simulation has finished? If you haven't here's an article explaining how you can download the results https:/...

  • Oliver Mashari commented,

    Hi Hyunjae, Yes so if you want to use a pressure load the way you have set it up looks fine but if you want to load the same area as the velocity load you will have to add  sdf2 pld1 vct1 vacm wate...

  • Oliver Mashari created an article,

    TOFD 2D

    This is a modelling guide to help you get started simulating Time of Flight Diffraction (TOFD) systems in OnScale. In this initial example you will be shown how to get the impedance of a basic 2D T...

    • Edited
    • 1 follower
    • 0 comments
    • 0 votes
  • Oliver Mashari commented,
    Official comment

    Hi Hyunjae, So yes Chloe is right you would define the velocity load using BOUN DEFN and NODE like this: boun      defn velocityload vel func       node $i2 $i4 $j2 $j2 This will not change any of ...

  • Oliver Mashari commented,

    Hi Arjin, We've just published a 2D phased array example you can find it here https://support.onscale.com/hc/en-us/articles/360002123037-Phased-Array-2D-Calculating-Delays Best regards, Oliver 

  • Oliver Mashari created an article,

    Phased Array 2D - Calculating Delays

    Model Description Ultrasonic phased arrays are a powerful technology used in a range of applications from biomedical imaging to non-destructive testing as well interest in the 5G RF domain to cope...

    • Edited
    • 1 follower
    • 0 comments
    • 0 votes
  • Oliver Mashari commented,
    Official comment

    Hi Xuan, So just so I'm clear - you are trying to import the geometry into PZFlex and this is where you are seeing the importation problems?  If this is the case the last update of PZFlex 2018 was ...