Cheung Tsz Kiu

Total activity 16
Last activity August 13, 2020 09:19
Member since July 17, 2020 09:34

Following 0 users
Followed by 0 users
Votes 0
Subscriptions 4

Cheung Tsz Kiu commented, August 13, 2020 09:19
But how to create a new data array? That is I don't know how to type the "datanameto" parameter.
- View comment
- 0 votes
Cheung Tsz Kiu commented, August 08, 2020 10:29
Thank you. I also want to ask when I simulate my model, then observe the result like "apmx", the highest pressure always occur inside the transducer, but the example graph I mentioned above didn't,...
- View comment
- 0 votes
Cheung Tsz Kiu created a post, August 03, 2020 10:08
Answered

Why the pressure plotting is so smooth compared with my simulation?
1. Community
2. OnScale Lab (Desktop Application)
How to attempt the smooth display like the left bottom graph one? My design and result is here: https://drive.google.com/drive/folders/17G-MbsawR-cDVmboQgwPcdvJC7eZC5ZM?usp=sharing Meanwhile, I wan...
- Edited August 05, 2020 10:22
- 2 followers
- 4 comments
- 0 votes
Cheung Tsz Kiu created a post, July 30, 2020 07:00
Does anyone having the material properties of E-solder 3022?
1. Community
2. OnScale Lab (Desktop Application)
I hope someone can provide the E-solder 3022 material properties of onscale, especially the damping properties. As E-solder 3022 seems like the common usage backing layer material. I can only find ...
- 1 follower
- 0 comments
- 0 votes
Cheung Tsz Kiu commented, July 28, 2020 04:55
Excuse me, is the voltage supply to the voltage load is set to default as 1 V?
- View comment
- 0 votes
Cheung Tsz Kiu commented, July 27, 2020 11:46
Can the time delay set to specific load? For example, I want the one side of my model vibrated first, then the next one start vibrate next 1e-6 second
- View comment
- 0 votes
Cheung Tsz Kiu commented, July 27, 2020 10:41
Thank youAnd I want to ask more, can I add the time delay for the voltage supply to each voltage load? And if I want to set the vibration of the piezoelectric crystal to vibrate in 4 MHz, is it ju...
- View comment
- 0 votes
Cheung Tsz Kiu created a post, July 23, 2020 11:37
Answered

How to make observe the ultrasound beam form inside the 3D model?
1. Community
2. OnScale Lab (Desktop Application)
Excuse me, I build the model and test it in water, but the output is just like the water cover the whole ultrasound beam form, what I can do to observe the cross-section of the ultrasound beam form...
- 2 followers
- 6 comments
- 0 votes
Cheung Tsz Kiu commented, July 17, 2020 14:20
Thank you very much Chole! It is solved! Best regards, Kevin
- View comment
- 0 votes
Cheung Tsz Kiu commented, July 17, 2020 14:09
Yes. But I checked out and tried the methods, it still not work.That's why I share the file to you to hope you can help me.
- View comment
- 0 votes