problem with "your model failed to estimate due to a syntax error". 回答済み
I just adding one more backing layer under the tutorial of 2D symmetric PZT plate, but the estimation just show me the massage above.
I have read the similar problem like this, but just cannot be solved.
6件のコメント
Hi there,
Welcome to the forum!
You can see what the error is by opening the file generated ending in '-estimate*.flxprt'. The error should be at the bottom of the file. If you need help understanding that error please let me know.
Best Regards,
Chloe
Yes, I found that, it shows "No electrode defined". Therefore, I sent you the file to check is anything I set wrong.
I am quite sure the mesh can cover the voltage load I set.
Check out this article for what to do for that error - https://support.onscale.com/hc/en-us/articles/360007264097-Troubleshooting-errors
Best Regards,
Chloe
Yes. But I checked out and tried the methods, it still not work.
That's why I share the file to you to hope you can help me.
The second point in the article is the issue with your model.
If you are working in Designer and using primitive shapes, check that their precedence is correct and that one is not overwriting another'.
If you preview your model you will see that it is just water because water has precedence 3 which is the highest.
The water is overwriting everything so you need to change the precedence of your shapes in the properties window.
Best Regards,
Chloe
Thank you very much Chole! It is solved!
Best regards,
Kevin
サインインしてコメントを残してください。
お探しのものを見つけられませんでしたか？
新規投稿