Kevin Chan
コメント
-
正式なコメント
Hi Bruno, Thanks for using the forum. The use of each command is the same, to apply a block of material to the mesh. The key difference is that REGN uses mesh nodes to define material. The values a...
-
正式なコメント
Hi Jessica, Yes it is possible to set up a loop to read in the different outputs from the sequential folder numbers: do MyLoop I 1 $nfiles 1 c Read datatext fName = '$I/simoutput.flxhst'read f1 $fN...
-
正式なコメント
Hi Faizan, Can you send a link to download your simulation files and we can take a look? Thanks Kevin
-
正式なコメント
Hi Stephanie, You can extract arrays at every timestep if you really wanted to, although this may generate a lot of data and have a slight penalty on solve time. You can decrease nrun for a finer ...
-
正式なコメント
Hi Vishnu, The frequency of interest is used as a parameter to control mesh resolution. We recommend 15 elements per wavelength to resolve discretize the waves sufficiently. This is typically set t...
-
Katsuhito, you should have access to the portal with your login credentials: https://portal.onscale.com On the left you will see a link to download the latest version. Hope this helps. Kevin
-
Hi, Make sure are using the latest version of the software. You can download in the Login Portal or within the application. Best regards, Kevin
-
正式なコメント
Hi Elizabeth, We typically work in SI units unless otherwise stated. Bulk Modulus will be measured in Pascals (Pa). If you have the the correct material properties for Air the atmospheric pressure ...
-
Hi Arjin, what image are you referring to?
-
正式なコメント
Hi Arjin, We are currently working on a Phased array example. We will send you a link when it becomes available. Thanks, Kevin