Chloe Allison
コメント
-
正式なコメント
Hi Vigneshwar, The estimator is only an estimate of the CHs and RAM required to run. It calculates the estimate by running one timestep of the simulation on your local machine. Sometimes this can...
-
正式なコメント
The memory allocated for numeric and character data can be set using the mem command. The default is 400 MB for numeric memory and 2 MB for character memory. If you get the above error you must inc...
-
Hi SD, Yes this is correct. Best Regards, Chloe
-
正式なコメント
Hi SD, Check out this example. Best Regards, Chloe
-
正式なコメント
Hi SD, Here is a zip folder of the process for getting the impedance when a circuit is defined. This cannot be done in Designer so I output your file to a *.flxinp and modified it. As mentioned...
-
正式なコメント
Hi Vigneshwar, Check out this article. Best Regards, Chloe
-
正式なコメント
Hi Taofeek Yusuf, Welcome to the forum! You can use Review or the Extrapolation Tool in the Post Processor to plot 2D beam patterns. Unfortunately we do not have the capability in OnScale to pl...
-
正式なコメント
Hi Vigneshwar, If you are changing the drive frequency you must also change the mesh too. See this article. The resonances might also be different because the input function does not have enough en...
-
SD, You will need to use Review to calculate the impedance because the impedance calculation in the Post Processor uses the charge record output from your simulation which is at the transducer, n...
-
正式なコメント
Hi SD, To calculate the impedance with the transformer you will need to take the charge at the source to see the effect of the transformer on the transducer (post-processor takes the charge on th...