Chloe Allison

1. Community
2. OnScale Lab (Desktop Application)
3. OnScale crashing when running grph commands

Hi James,  Can you please share the log files via your preferred file sharing service and we can take a look for you. Best Regards, Chloe

• View comment
• Created November 12, 2021 13:30
• 0 votes

1. Community
2. OnScale Lab (Desktop Application)
3. OnScale crashing when running grph commands

Hi James, This could be a couple of things. Are you using remote desktop - we do not support this? Also does your graphics card support OpenGL 2.0 or higher? Best Regards, Chloe

• View comment
• Created November 12, 2021 12:55
• 0 votes

1. Community
2. OnScale Lab (Desktop Application)
3. Plotting Impedance in Water

Hi Laura, Are you able to share your model with us via your preferred cloud sharing service? 0.8 seconds is a long time. What is your frequency of interest? Is it a very low frequency transducer? I...

• View comment
• Created October 12, 2021 12:50
• 0 votes

1. Community
2. OnScale Lab (Desktop Application)
3. Excite Plane wave

Thank you for sharing Dave!

• View comment
• Created September 24, 2021 13:02
• 0 votes

Official comment

1. Community
2. OnScale Lab (Desktop Application)
3. Less sensitive to low frequency

Hi Selena,    I had a look at your models, I wasn't sure which one you are working on but have a look at my comment on your previous post and it should help you get better results. You need to adju...

• View comment
• Created September 14, 2021 18:38
• 0 votes

Official comment

1. Community
2. OnScale Lab (Desktop Application)
3. How to set damping ratio, driving frequency and driving damping?

Hi Selena, Welcome to the forum. It looks like you have generated these files in Designer Mode so I will give you instructions for this.  Our project material database is where it looks like you ha...

• View comment
• Edited September 14, 2021 18:35
• 0 votes

1. Community
2. OnScale Lab (Desktop Application)
3. Model quits before end time with 'Flex - Illegal access termination'

Hi Laura, This is just a case of not assigning enough hardware resources, the resulting *.flxhst file is 16.89 GB so I ran on the cloud with 32 CPUs and 32 GB of RAM and it ran successfully. Howeve...

• View comment
• Edited September 08, 2021 13:25
• 0 votes

Official comment

1. Community
2. OnScale Lab (Desktop Application)
3. Model quits before end time with 'Flex - Illegal access termination'

Hi Laura,   Can you share your files via your preferred file sharing service and we can take a look please? Thanks, Chloe

• View comment
• Created September 03, 2021 14:51
• 0 votes

Official comment

1. Community
2. OnScale Lab (Desktop Application)
3. Time difference of Ricker Wavelet

Hi Vincent,   There appears to be some bugs in the tool (notice the time delay is in seconds but applies in microseconds). The peak of the Ricker Wavelet should be at 4 us when there is zero time d...

• View comment
• Created September 03, 2021 14:42
• 0 votes

1. Community
2. OnScale Lab (Desktop Application)
3. Time difference of Ricker Wavelet

Hi there,   Could you please provide a link to the tutorial this is from?   Best Regards, Chloe

• View comment
• Created August 25, 2021 15:14
• 0 votes