Cheung Tsz Kiu

1. Community
2. OnScale Lab (Desktop Application)
3. Why the pressure plotting is so smooth compared with my simulation?

But how to create a new data array? That is I don't know how to type the "datanameto" parameter.

• View comment
• Created August 13, 2020 09:19
• 0 votes

1. Community
2. OnScale Lab (Desktop Application)
3. Why the pressure plotting is so smooth compared with my simulation?

Thank you. I also want to ask when I simulate my model, then observe the result like "apmx", the highest pressure always occur inside the transducer, but the example graph I mentioned above didn't,...

• View comment
• Created August 08, 2020 10:29
• 0 votes

1. Community
2. OnScale Lab (Desktop Application)
3. How to make observe the ultrasound beam form inside the 3D model?

Excuse me, is the voltage supply to the voltage load is set to default as 1 V?

• View comment
• Created July 28, 2020 04:55
• 0 votes

1. Community
2. OnScale Lab (Desktop Application)
3. How to make observe the ultrasound beam form inside the 3D model?

Can the time delay set to specific load? For example, I want the one side of my model vibrated first, then the next one start vibrate next 1e-6 second  

• View comment
• Created July 27, 2020 11:46
• 0 votes

1. Community
2. OnScale Lab (Desktop Application)
3. How to make observe the ultrasound beam form inside the 3D model?

Thank youAnd I want to ask more, can I add the time delay for the voltage supply to each voltage load?  And if I want to set the vibration of the piezoelectric crystal to vibrate in 4 MHz, is it ju...

• View comment
• Created July 27, 2020 10:41
• 0 votes

1. Community
2. OnScale Lab (Desktop Application)
3. problem with "your model failed to estimate due to a syntax error".

Thank you very much Chole! It is solved!   Best regards, Kevin

• View comment
• Created July 17, 2020 14:20
• 0 votes

1. Community
2. OnScale Lab (Desktop Application)
3. problem with "your model failed to estimate due to a syntax error".

Yes. But I checked out and tried the methods, it still not work.That's why I share the file to you to hope you can help me.

• View comment
• Created July 17, 2020 14:09
• 0 votes

1. Community
2. OnScale Lab (Desktop Application)
3. problem with "your model failed to estimate due to a syntax error".

Yes, I found that, it shows "No electrode defined". Therefore, I sent you the file to check is anything I set wrong. I am quite sure the mesh can cover the voltage load I set.

• View comment
• Created July 17, 2020 11:37
• 0 votes