Defining the loads of a pressure sensor + creating curved surfaces 回答済み
I'm a researcher at Glasgow Uni with relatively little OnScale experience and I'm having a little trouble when it comes to defining my loads for a passive sensor I have designed. Basically, the purpose of the sensor is to detect pressure waves from cavitating bubbles and the outputs I want are things like sensitivity and full width half maximum etc. However, I'm unsure how to load the model to input a pressure wave incident on the front face and output this data (i.e do I need electrodes etc). Any help would be greatly appreciated. the design is as shown below.
Also one last question - Is it possible to make a concave curved face sensor in OnScale designer that is exactly the same as this one, only concave? Any help would be greatly appreciated.