Chloe Allison

1. Designer Tutorials
2. Beginner's Tutorial
3. Viewing the Simulation Results

Hi James, All of the units we use are SI units. Best Regards, Chloe.

• View comment
• Created October 24, 2019 15:18
• 0 votes

1. Designer Tutorials
2. Beginner's Tutorial
3. Adding Outputs

Hi James, The above is describing how to add an acoustic pressure time history from the field data. To plot the whole field data you would set Output Type as field data. Best Regards, Chloe.

• View comment
• Created October 24, 2019 15:16
• 0 votes

1. Designer Tutorials
2. Beginner's Tutorial
3. Adding Keypoints

Hi James, We have changed from VTK to Open Cascade so the ruler ticks are no a feature but you can enter the value you want directly into the keypoint dialogue box. Best Regards, Chloe.

• View comment
• Created October 24, 2019 15:14
• 0 votes

1. Designer Tutorials
2. Beginner's Tutorial
3. Configuring the Mesh

Hi James, If you do not set the extents of your model and you set the water width to a parameter in the parameter table, changing this width will not automatically update the extents so these need...

• View comment
• Created October 24, 2019 14:54
• 0 votes

Official comment

1. Community
2. OnScale Lab (Desktop Application)
3. How can I import 2-D geometries?

Hi there, It could be that the conversion is not working properly, have you tried using OnShape to output into a different format like *.step? Could you send your *.iges file across to us and we ca...

• View comment
• Edited May 07, 2020 14:21
• 0 votes

1. General Documentation
2. Meshing
3. What are #keycord and #keyindx

Thank you Whayne

• View comment
• Created October 17, 2019 08:08
• 0 votes

Official comment

1. Community
2. OnScale Lab (Desktop Application)
3. Hi I found something wrong (memory overflow?)

Hi there,   It looks like your model is going unstable after 0.4ms, pmin looks very high. This could be caused by the absorbing boundaries. I would try using impedance boundaries 'side xmin impd'. ...

• View comment
• Created October 15, 2019 08:04
• 0 votes

Official comment

1. Community
2. OnScale Lab (Desktop Application)
3. I don't know the cause of the error message.

Hi there,   It sounds like you are using the wrong type of file. In Designer mode you must run *.jfp's on the cloud. In Analyst Mode you must run *.flxinp files on the cloud.   Best Regards, Chloe.

• View comment
• Created October 15, 2019 07:58
• 0 votes

Official comment

1. Community
2. OnScale Lab (Desktop Application)
3. I don't understand the unit display.

Hi there,   Pressure is in Pascals and speed is in m/s.    Best Regards, Chloe.

• View comment
• Created October 15, 2019 07:56
• 0 votes

1. Community
2. OnScale Lab (Desktop Application)
3. Adaptiv Meshgrid

Hi Michael,   We are currently working on a CAD solver which allows you to import Solidworks files and use unstructured meshing so this would be the solution to your problem. However, we have not r...

• View comment
• Created October 10, 2019 13:53
• 0 votes